speeddownloadtix.blogg.se - Installing windows 7 on samsung 850 evo

Configure the USB/CD/DVD drive as the primary boot device in the BIOS. Please refer to the Make Bootable USB or Burn Bootable CD/DVD section for more information.ġ. The following steps assume that all necessary files are present on the USB/CD/DVD disk. Do I have to update Firmware if it’s available?.Firmware Update cannot be performed on a RAPID Enabled SSD Please do not power off during firmware update Before updating the firmware, please check whether your SSD's firmware is the latest version or not Before updating the firmware, please back up your data and close all running applications (except Magician) When a new firmware is available for Samsung SSD on your system, a message "New Version of Firmware Detected (Version Number)" appears next to the Update button on the Firmware Update screen.If you encounter any problem with the Live firmware Update feature and your SSD is 470 series, you can perform DOS-based firmware update utility via bootable CD/DVD/USB. Samsung occasionally provides new firmware in order to improve SSD performance, compatibility, and user experience.įirmware update is recommended whenever a new version is released. Should I buy an expansion card to add SATA 6GB/s (SATA III) support? I have a SATA 3Gb/s (SATA II) motherboard.MSI Intel chipset/ AMD chipset : Integrated Peripherals > On-Chip ATA Devices > In RAID Mode, select AHCI.

GIGABYTE AMD chipset : Integrated Peripherals > OnChip SATA Type In this menu, select AHCI.GIGABYTE Intel chipset : Integrated Peripherals > SATA RAID/AHCI Mode In this menu, select ""AHCI"".

ASUS AMD chipset : Main > Storage Configuration > SATA Mode Select In this menu, change to AHCI Mode.

ASUS Intel chipset : Main > Storage Configuration > Configure SATA as In this menu, select AHCI.

Enter BIOS setup, and change SATA settings from IDE to AHCI. Double-click it to change it to ""0""and then reboot.

HKEY_LOCAL_MACHINE > SYSTEM > CurrentControlSet > services > msahci In this menu, you will see an item named Start. Go to Start>Run, and then enter ""regedit"" in the Run window and press Enter to launch the Registry Editor. Change the settings as shown below, or reinstall Windows. When Windows is installed without enabling the AHCI mode in BIOS setup, an error may occur during the booting. Boot the system, enter BIOS setup, and change SATA settings from IDE to AHCI. The best way to enable AHCI is to go to BIOS and enable AHCI mode, and then install the operating system.